Create your free account and get 10 bonus questions when you confirm your email. No card needed. Create free account

Try it free

P0406: EGR Sensor A Circuit High

Severity: medium

Updated: 15 Nov 2026 · Generic OBD-II code (SAE J2012 / ISO 15031-6). Written with AI and reviewed; translated automatically from the Spanish original.

What it means

The code indicates that the ECU is receiving, from the EGR sensor A circuit, a voltage signal above the expected range. On many vehicles that sensor reports the position of the exhaust gas recirculation valve, and the ECU compares that reading with the position it has commanded. The code is stored if the voltage exceeds the threshold for a set period of time or if the reading is not consistent with the operating state. The usual causes tend to lie in the wiring or the sensor, although a stuck valve can also produce an inconsistent reading. In some designs the position does not come from a separate sensor but from the actuator motor itself, and this depends on the manufacturer and model.

Can I keep driving?

Yes, but have it checked soon.

The car can normally be driven, but the fault can get worse or damage other parts over time (the catalytic converter or the particulate filter, for example). Book a diagnosis in the next few days.

If in doubt, put safety first: a red or flashing warning light, smoke, a burning smell or any change in the brakes or steering are reasons to stop.

Got P0406? Ask about your car

Tell us your car and what you notice: we answer right here, no account needed.

Symptoms

  • Warning light on in the instrument cluster.
  • Possible rough idle or tendency to stall when stopping.
  • Possible slight loss of power, especially when accelerating.
  • Possible increase in fuel consumption, depending on the case.
  • On many vehicles nothing is noticeable during normal driving.

Common causes

  • Damaged wiring or connector, with corrosion, moisture or a pinched cable causing high voltage on the signal.
  • Faulty or worn EGR position sensor.
  • EGR valve clogged with carbon or stuck, preventing the sensor from reading a consistent position.
  • Fault in the reference supply or sensor earth.
  • Internal ECU fault, very uncommon.
  • Make-dependent: the sensor type and its location vary by manufacturer.

What to check

  • Wait for the engine and exhaust manifold to cool before touching the EGR valve or its pipes, as they can be very hot and cause burns.
  • Visually inspect the connector and harness, looking for pinched cables, damaged insulation, moisture or corrosion.
  • Check the EGR valve for carbon build-up and confirm it moves freely, if the diagnostic equipment allows it to be actuated.
  • Read the position signal in live data with the engine off and at idle, and compare it with the position commanded by the ECU.
  • With the connector disconnected and the ignition on according to the manufacturer's diagram, measure the sensor's reference voltage and earth with a multimeter.
  • Check the continuity of the wiring between the ECU and the sensor, and rule out short circuits to positive.
  • Replace the sensor or valve only if the above tests confirm it, and repeat the test to verify the repair.

Frequently asked questions

Can I keep driving with code P0406?

Normally yes in the short term, because this code does not usually compromise safety or damage the engine immediately. It is worth having it checked soon, especially if you notice rough idle, loss of power or increased fuel consumption. If the engine runs very roughly, tends to stall or the vehicle goes into a limp mode, avoid driving it and take it to a garage as soon as possible. If in doubt, a professional should carry out the diagnosis.

Can I just clear it? Clearing the code does not fix the fault: if the cause is still there, it comes back, and with the engine warning light on the car will fail its roadworthiness test (MOT in the UK).

General information about a generic code. The exact causes depend on the make and engine: confirm them with a diagnosis before replacing parts.

More codes: auxiliary emission controls

All OBD codes in English